Custom machining request checklist
A custom part is only as good as the information that goes into the shop. When a request is missing a dimension, material callout or coating requirement, the work stalls or gets reworked. A complete request gives the machinist a clear target and gives the buyer a quote that holds up.
Our in-house machining team works from drawings, samples and detailed specifications. This is the information we need to move a job through the shop.
Start with the job
Describe what the part needs to do before describing the part itself. The application tells the shop which features are critical and which tolerances need attention.
A good opening note sounds like: “This is a replacement seat for a valve body. The sealing face is critical. We need two pieces for a maintenance job in the Permian Basin.” That gives the shop context that a bare sketch usually misses.
The drawing or sample
If you have a drawing, send the current revision and confirm the units. If you are sending a sample, tell us which features must be matched and which can be adjusted. A marked-up drawing or photo with dimensions is better than a clean image with no callouts.
Useful drawing details include:
- Overall dimensions and the dimensions that matter most
- Tolerances and surface finish requirements
- Thread type, size and class
- Material and heat treatment or condition
- Critical faces, bores or sealing surfaces
- Revision number and date
- Any features that must remain untouched on a modification
Send the revision you actually want
Old drawings cause new problems. Confirm the revision and make sure everyone is quoting the same version before work begins.
Material
Specify the material when it is known. If the material is open, say so and explain what the part needs to withstand. Substituting material is not a shop-floor decision when the application depends on it.
Include any requirement for stainless steel, alloy steel or another grade, along with the condition or finish the part needs. If the part will be coated, confirm the material before coating is quoted.
Quantity
Tell us whether the immediate need is for a single part or a larger quantity. A clear quantity helps the shop plan setup, material and timing.
If the part is likely to repeat, mention it. Repeat work can be planned differently from a one-time requirement, and the shop may want to preserve the setup information.
Coating and finish
A machined part is not necessarily a finished part. If the job needs protection, specify the coating or finish. We provide Corvel and Scotchkote 134 plastic-coated products, and we can coordinate those requirements with the machining work.
Be specific about surfaces that should not be coated, threads that need masking, and any color or coverage requirement. These details affect handling and lead time.
Delivery and timing
Tell us when the part is needed and where it needs to go. We can support pickup at our Abilene warehouse, daily route delivery in the Permian Basin, Barnett Shale, and Eagle Ford, or LTL freight to your location.
If the required date is tied to a shutdown, scheduled maintenance or a customer commitment, say that up front. The shop can tell you whether the date is realistic before you promise it to anyone else.
Application context
The details below are not always required, but they help the shop make better decisions:
- Media and operating pressure
- Temperature range
- Connection or mating part
- Installation constraints
- Known failure of the existing part
- Any customer specification or standard that applies
What happens next
We review the requirement with you before work begins. The conversation covers material, dimensions, quantity, coating and timing. Once the scope is clear, our shop machines the part in house, and we coordinate pickup, route delivery or freight.
To start, send the requirement or call(325) 437-3445. If you have a drawing, bring it. If you have a sample, bring it. If you only have a problem to solve, bring that too.